include /* https://github.com/BelfrySCAD/BOSL2 */ include include //$fn = 10; // Equation: 144=2*12+2*117.168*sin(a)+l*cos(a),21=2*117.168-2*117.168*cos(a)+l*sin(a),a>0,a0 end_length = 12; // Same as normal ascending track slope_radius = 117.168; // Same as normal ascending track slope_angle = 12.5681; // Calculated based on above equation straight_length = 70.7028; // Calculated based on above equation ramp_height = 21; // Difference between 3 Brio bridges tall and fireplace ramp_length = 144; // Length of an A piece module tall_nest() { translate([0, track_width/2, -track_height/2]) scale([1,1,2]) track_nest(); translate([0, track_width/2, track_height/2 - cc]) rotate([0, 0, 45]) cube([track_nest_neck_width, track_nest_neck_width, track_height + 2*cc], center = true); } turtle_cmds = ["move", end_length, "arcleft", slope_radius, slope_angle, "move", straight_length, "arcright", slope_radius, slope_angle, "move", end_length]; path = turtle(turtle_cmds); difference() { path_extrude(path) track_blueprint(grooves = true, part_chamfers = true, both_sides = true); // Add nest translate([0, track_height, -track_width]) rotate([90, 0, 0]) tall_nest(); // Corner chamfer start rotate([-90, 0, 0]) for (y = [0, track_width]) { translate([0, y, track_height/2]) rotate([0, 0, 45]) cube([track_chamfer, track_chamfer, track_height], center = true); } // Corner chamfer end translate([0, ramp_height, 0]) rotate([-90, 0, 0]) for (y = [ 0, track_width]) { translate([ramp_length, y, track_height/2]) rotate([0, 0, 45]) cube([track_chamfer, track_chamfer, track_height], center = true); } } // Add plug translate([ramp_length, ramp_height+track_height, -track_width/2]) rotate([90, 0, 0]) track_plug();